Ricoh AP204 Operator's Manual page 227

Appendix
printer refuse
At the beginning of the message, the IP address is displayed in parentheses.
When using SNMP
Exit snmpdSNMP
recvfrom:packet discarded,length(Recep-
tion packet length)> (Packet size),from
addr <Address of partner point>
session <Community name appointed>
not defined
snmpin:Bad use of session <community
Name> from <IP Address>
6
snmpin:error in snmpdecipher,code (<Er-
ror No.>)
snmpin:error in snmpservsend,code (<Er-
ror No.>)
snmpin:pkt too large,code (<Error num-
*1
ber>)
snmpin:error in sending too large request
back,code (<Error number>),giving up
snmpin:received bad version
Error numbers in the messages are codes for service representatives.
84
Something is wrong with your printer.
Confirm the status of the printer.
The agent is complete. Reset the printer or
turn the printer off and on.
The received packet was ignored since the
length of the packet exceeds the limit.
Confirm whether the administration sta-
tion sent a packet whose length is longer
than 1024 bytes.
The community name of the received
packet is not defined. Confirm that the
community name of the administration
station is the same as that specified to the
printer.
The community name of the received
packet is not the same as that of the ad-
ministration station. Confirm the commu-
nity name specified to the printer.
The error occurred on the received packet.
Check if the number of the objects sent
from the administration station is more
than 31 and if there are wrong MIB re-
quests.
Cannot send a response packet. Normal-
ly, this message is followed by the follow-
ing messages.
The response packet to the request is too
big to send. Reduce the number of the ob-
jects per request.
The packet notifying the error is too big to
send. Reduce the number of the objects
*2
per request.
The version of the received packet is in-
valid. Confirm that the version of the ad-
ministration station is version-1(0).