Ricoh AP204 Operator's Manual page 265

Using RICOH-SCRIPT2 with Windows
Halftone
Select the halftone pattern you want to use for printing. The following items
are available: [Use Printer Halftone] and [Use System Halftone].
Halftone Setup
You can change the halftone settings.
Form to Tray Assignment
2
Use this to assign the paper size to each tray. All paper sizes that can be used
with Windows NT4.0 are displayed, however, only the paper sizes supported
by the printer can be selected. Normally you do not need to change this set-
ting.
Reference
For more information on paper sizes supported by the printer, see the "Op-
erating Instructions" that comes with your printer.
Note
If the paper tray you want to use is not available here, even though it is
physically installed, use the [Device Settings] tab to make the printer recog-
nize the tray correctly.
Font Substitution Table
Use this to edit the TrueType font substitution table. Under [Font Substitution
Table], the TrueType fonts installed on the computer are displayed. Select the
setting you want to use from the [Change Setting] for each TrueType font.
Job Timeout
Use this to set a job timeout period in the range of 0 to 32767 seconds. Setting
a value to 0 turns the job timeout off.
Wait Timeout
Use this to set a wait timeout period in the range of 0 to 32767 seconds. Setting
a value to 0 turns the wait timeout off.
Total Printer Memory
Use this to specify the amount of memory actually installed in the printer. The
following settings are available: [16 MB ], [32 MB ], [48 MB ].
Option Tray
Use this to specify if the optional tray unit is installed on the printer. The fol-
lowing settings are available: [None] and [Tray 2].
Reference
For more information on the options, see the printer's "Operating Instruc-
tions".
24
P.23 " [Device Settings] Tab"