Hsb™ High Speed Bus; Hsb Connection - Raymarine RL70C Owner's Handbook Manual

Chapter 8: Installation
HSB™ High Speed Bus
The High Speed Bus (HSB) provides extremely rapid transfer of data between
master and repeater displays. Any two devices that conform to the HSB
standard can be inter-connected. With an HSB and a SeaTalk connection most
data available can be controlled and displayed by either unit (Guard zones
cannot be viewed or controlled on the chartplotter display, nor on a repeater
display that is not directly connected to a scanner. Likewise, radar timed
transmission is not available on a repeater display).
For example, you could connect an HSB Radar display and an HSB
Chartplotter display, to enable you to display and control both radar and chart
data on either or both displays. The HSB Series displays allow you to select
either type of data for display, or display both types at the same time, in half-
screen windows.
When two displays are used, the following functionality will be obtained at
each display (assuming a radar scanner is connected to Display 1)
Scanner
Connected
Yes
Yes
Yes
Yes
No
No
Any HSB Series display can be combined with the 7" LCD display to create
two display systems.

HSB Connection

An In/Out connector is provided for an HSB series repeater or chartplotter
display.
Note: The HSB cables are fitted with ferrite clamps at each end to ensure EMC
conformance. The cables are available in lengths of 1, 3, 6, 10 and 20 m.
Display 1
Type Functionality
RL70 Radar master
RL70 Radar master
Chart repeater
RL70RC Radar master
Chart master
RL70RC Radar master
Chart master
Chart repeater (disp.2)
RC520 Chart master
RC520 Chart Master
Chart repeater (disp. 2)
161
Display 2
Type Functionality
RL70 Radar repeater
RC520/ Chart master
RL70RC Radar repeater
RL70 Radar repeater
Chart repeater
RC520/ Chart master
R70RC Chart repeater (disp. 1)
Radar repeater
RL70 Chart repeater
RC520/ Chart master
RL70RC Chart repeater (disp. 1)