Stop Follow Or Stop Goto - Raymarine RL70C Owner's Handbook Manual

Chapter 5: Standard Chart Operations
3. To return to the default soft key display, move the cursor away from the
waypoint.
➤ To navigate directly to the cursor position:
1. Use the trackpad to position the cursor as required.
2. Press the GOTO default soft key, followed by GOTO CURSOR.
If navigation is currently in progress you are warned "Already following
route. Cancel route and goto cursor ?".
To cancel the GOTO CURSOR operation, press NO.
To continue with the GOTO CURSOR operation (and stop the current GOTO
ROUTE), press YES.
The chartplotter places a temporary waypoint as the target and starts to
navigate towards it. The waypoint is shown as a square with a circle and dot
in the centre, and is connected to the vessel's starting position with a dashed
line.
The soft key STOP GOTO is displayed.
Note: The temporary waypoint is not added to the waypoint list; when the
GOTO is complete, or is stopped, the temporary waypoint is erased.
3. To return to the default soft key display, move the cursor away from the
waypoint or press CLEAR.

Stop Follow or Stop Goto

➤ To stop following the route or target point
either:
If necessary, press the GOTO soft key, then press the STOP
GOTO/FOLLOW soft key.
Or:
Move the cursor over any waypoint or leg in the current route, then press
the STOP GOTO/FOLLOW soft key.
The dotted line from your vessel to the target waypoint disappears.
If you subsequently use the FOLLOW ROUTE soft key to restart navigation, the
route is followed from the point at which it was stopped. This is indicated by a
square around the target waypoint. If you want to follow from another waypoint
you can initiate the follow then use the WAYPOINT ADVANCE or FOLLOW FROM
HERE soft key to step through the route.
105