Resetting The System - Raymarine RL70C Owner's Handbook Manual

172

9.2 Resetting the System

There are four types of reset available for the Pathfinder Radar:
• Factory Reset: This resets all values back to their original factory settings.
CAUTION:
The factory reset clears the radar unit's Marks database, and in
chartplotter units, the Waypoints and Routes databases.
• Advanced Settings Reset: Radar units only – this resets the advanced radar
settings back to their factory defaults (see Section 7.5).
• Power-On Reset: When you turn the display off and on again, the screen
reverts to the radar or chart picture with all windows cleared.
• Picture Reset: Press and hold the DISPLAY key for two seconds to return
the screen to the full-screen picture with all windows and grouped data boxes
cleared.
At power-on, the last-used values are retained for all the options, except for
those listed in the following table which are reset to the factory default each
time.
Item
Heading Mode
Rain
FTC
Alarm
Zoom
Windows
Contrast Level
Backlight Level
➤ To perform a factory reset:
1. Put the radar into Standby mode.
2. Press MENU.
3. Press the SYSTEM SET UP soft key to display the System Set Up page (see
Section 7.3 for details).
4. Press and hold MENU for 5 seconds.
A countdown timer is displayed. If you release the MENU key before the
timer reaches zero, the reset is not performed.
When the reset request has been accepted, the radar system restarts, with
the magnetron countdown sequence.
The factory default settings are listed in Section 7.5.
Power-on setting
Head Up (radar); North Up (chart)
OFF (but value stored) – radar only
OFF (but value stored) – radar only
ON, with last-used value
OFF
OFF
Within 30-70% range, if last-used value outside this range
ON at 42% if previously selected
HSB Series LCD Display