87076_1.book Page 23 Monday, March 10, 2008 9:21 AM
Chapter 2: Installing the system
2.7 Pilot Controller
Fitting
The ST6002 Pilot Controller is supplied with an 4 m cable for connection to the
SeaTalk bus. Ensure that your mounting location is within 4 m of a suitable connection
point. You may purchase a longer cable if required.
Fit the controller in accordance with the separate instruction leaflet.
Connect controller and SeaTalk bus
The Pilot Controller connects to SeaTalk at the Course Computer, as shown in
following diagram.
Pilot Controller
Note:
You will need an additional cable to connect your controller to an existing SeaTalk instru-
ment.
SeaTalk power connections
The exact manner in which connections are made depends on how power is supplied
to SeaTalk:
•
If power is supplied by the Course Computer, connect the red and yellow wires
and the screen to the Course Computer.
•
If power is supplied from an external source, connect only the yellow wire and the
screen to the Course Computer. Do NOT connect the red wire.
Red
Connect Red wire only if SeaTalk
is to be powered from Course
Computer. See SeaTalk power
connections below, for details.
SeaTalk
23
Yellow
Screen
D10619-1