Raymarine RL70C Owner's Handbook Manual page 129

Chapter 6: Further Chart Operations
2. Use the trackpad to move the selection bar up or down the list. As each line
is highlighted, the soft key labels are updated to show the current settings
and controls, as shown in the example above.
3. Use the up or down soft keys to change the variable controlling the alarm.
For example, for the arrival alarm you can adjust the radius from the
waypoint at which the arrival alarm will be triggered.
The alarm distances can be set in the range 0.01 to 9.99 nm, in steps of
0.01nm. The timer is set in minutes and seconds, and the alarm clock in
hours and minutes.
4. If required, press the ALARM OFF ON soft key to toggle the alarm on or off. If
you turn an alarm off, its value is retained and will be used when you turn
the alarm on again.
Note: You can turn all the alarms and timers on and off, except for the
Arrival Alarm which is always on.
5. Press ENTER to save the changes and clear the list.
ALARMS SET UP
115
D4265-1