Advanced Tools; Using The Ping Test Tool - Cisco FLUIDMESH FM3200 Endo Installation And Configuration Manual

Backhaul FM3200 Endo Cisco Ultra-Reliable Wireless
1. Click the Export as JSON icon on the upper right part of the FM-
QUADRO view (below).
• The Export as JSON dialog will be shown.
2. Click the Export button to export the network representation as a
*.JSON file. Alternatively, click the Cancel button to leave the
dialog without exporting.
• If you clicked the Export button, a download dialog will be
• The *.JSON file will be downloaded in a *.ZIP package.
3. Forward the *.JSON file, and the diagnostic file exported from the
device status page, to Fluidmesh Technical Support.

7.5.3. Advanced tools

The Advanced Tools window contains tools to diagnose the condition of
the wireless network.
• The Ping test tool sends pings to a user-specified IP address.
• The Bandwidth test tool tests the bandwidth capacity of the wireless
link between the Fluidmesh unit and a user-specified IP address.
• The Path MTU tool tests the size of the maximum transmission unit.
To open the Advanced Tools dialog, click the -advanced tools link under
NETWORK CONTROL in the left-hand settings menu.

Using the Ping test tool

The Ping test can be run while the network is under load (to test
operational performance), or with the network unloaded (to test installed
capacity). To use the Ping test tool, do the following steps:
1. Determine which wireless link is to be tested between the
Fluidmesh unit and another unit in the wireless network. Get the
IP address of the other unit.
© 2020 Cisco and/or its affiliates. All rights reserved.
IMPORTANT
The dialog contains important information
regarding confidentiality and FM-QUADRO
functionality. Read and understand the dialog
before clicking the Export button.
shown on your screen. Save the generated fmquadro-
topology file to your computer.
Open the *.ZIP package to access the *.JSON file.
Page 85 of 177