Adjusting The Transparency Of The Aerial Map View - Cisco FLUIDMESH FM3200 Endo Installation And Configuration Manual

Backhaul FM3200 Endo Cisco Ultra-Reliable Wireless
1. Get an aerial image of the area in which the wireless network and
LAN are installed. The image must conform to the following
requirements:
• Image formats: *.PNG, *.JPG or *.SVG only.
• File size: Less than or equal to 150 Kilobytes.
• Images can be uploaded to FM-QUADRO using Google
2. Click the Settings icon on the upper right part of the FM-
QUADRO view (below).
• The Appearance / Background dialog will be shown.
3. If the Appearance settings are shown, click the Background
heading.
4. Click the Image radio button.
• Upload your file and Preview sections will be shown.
5. Use the Upload your file section to upload the aerial image.
6. To save your changes, click the Save changes button.
Alternatively, click the Discard button to leave the dialog without
saving any changes.
• Your chosen aerial image will be shown as a visual layer
7. If needed, move the Fluidmesh device icons and/or tooltips to suit
the aerial image as shown in
device icons" (page

Adjusting the transparency of the aerial map view

You can adjust the transparency level of the aerial map view. This is a
useful way to increase the visual definition of device icons, tooltips and
link lines against strong background colors.
To adjust the transparency of the current aerial map view, do the steps
that follow:
© 2020 Cisco and/or its affiliates. All rights reserved.
TIP
Suitable aerial images can be created and
downloaded using
instructions on how to use Google Earth are
available here.
Chrome, Firefox, Safari or Microsoft Internet Explorer.
Fluidmesh recommends using the latest version of Google
Chrome or Firefox.
underneath the current network view.
80).
Google Earth. Basic
"Changing the relative position of
Page 83 of 177