Important Considerations For Wireless Settings; Point-To-Point And Point-To-Multipoint Considerations - Cisco FLUIDMESH FM3200 Endo Installation And Configuration Manual

Backhaul FM3200 Endo Cisco Ultra-Reliable Wireless
• Operation in the 4.9 GHz band must be enabled using a
5. If Advanced configuration mode was selected, choose the
required channel bandwidth from the Channel Width (MHz)
drop-down. Note that the radio units on both sides of a wireless
link must be set to the same channel width value. A channel
width mismatch will result in degraded communication between
the units.

Important considerations for wireless settings

The following sub-sections contain important technical and regulatory
information
RADIO window.
• For information on the effects of network topology on frequency
selection,
considerations" (page
• For information on how to avoid network co-location interference,
refer to
• For information on the effects of channel width on data rate and
throughput, refer to
• For information on using dynamic frequency selection to avoid
interference with terminal doppler weather radar, refer to
frequency selection considerations" (page

Point-to-Point and Point-to-Multipoint considerations

If a Fluidmesh radio transceiver unit's FluidMAX Autoscan setting is
enabled, and the unit is assigned a Subordinate role within a point-to-
multipoint network topology:
• The Subordinate unit will mimic the frequency setting of the
principal unit that shares its cluster ID.
• The Subordinate unit's manual frequency selection setting will be
disabled by default.
© 2020 Cisco and/or its affiliates. All rights reserved.
operating in the same area. The frequencies shown on the
Frequency (MHz) selector are the carrier frequencies.
Fluidmesh software plug-in. Refer to
management" (page 131)
band is not available in Brazil and Canada.
CAUTION
Before finalizing the settings on the WIRELESS
RADIO window, refer to
for wireless settings" (page 62)
contains important information that may influence
your choice of wireless settings.
that influences the
refer to "Point-to-Point
62).
"Co-location considerations" (page
"Channel width considerations" (page
"Plug-In
for details. Note that the 4.9 GHz
"Important considerations
below. This section
settings on the
and Point-to-Multipoint
63).
64).
Page 62 of 177
WIRELESS
63).
"Dynamic