Advanced Tools; Using The Ping Test Tool - Cisco FM3200 Base Installation And Configuration Manual

• The Export as JSON dialog will be shown.
2. Click the Export button to export the network representation as a
*.JSON file. Alternatively, click the Cancel button to leave the
dialog without exporting.
• If you clicked the Export button, the *.JSON file will be
downloaded as a *.ZIP package. Open the *.ZIP package
to access the *.JSON file.
3. Forward the *.JSON file, and the diagnostic file exported from the
device status page, to Cisco Technical Support.

6.5.3. Advanced tools

The Advanced Tools window contains tools to diagnose the condition of
the wireless network.
• The Ping test tool sends pings to a user-specified IP address.
• The Bandwidth test tool tests the bandwidth capacity of the wireless
link between the Cisco unit and a user-specified IP address.
• The Path MTU tool tests the size of the maximum transmission unit.
To open the Advanced Tools dialog, click the -advanced tools link under
NETWORK CONTROL in the left-hand settings menu.

Using the Ping test tool

The Ping test can be run while the network is under load (to test
operational performance), or with the network unloaded (to test installed
capacity). To use the Ping test tool, do the following steps:
1. Determine which wireless link is to be tested between the
Cisco unit and another unit in the wireless network. Get theIP
address of the other unit.
2. Enter the IP address of the other unit in the Ping (10 packets
only) field
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
IMPORTANT
The dialog contains important information
regarding confidentiality and FM-QUADRO
functionality. Read and understand the dialog
before you click the Export button.
(Figure 31 (page 86)).
Page 85 of 176