Cisco FLUIDMESH FM3200 Endo Installation And Configuration Manual page 123

Backhaul FM3200 Endo Cisco Ultra-Reliable Wireless
2. Set the device name by typing it in the Name: field.
3. Set the functionality of the unit's hardware Reset button by
clicking the Reset Button function: drop-down and clicking the
needed option as described below:
• Disabled: The hardware Reset button will be disabled.
• Enabled: The hardware Reset button will be enabled.
• Factory: The hardware Reset button functionality will be
© 2020 Cisco and/or its affiliates. All rights reserved.
Figure 49. Configurator GUI (MISC SETTINGS dialog)
NOTE
It is not essential to specify the device name, but it is
strongly recommended. Failure to specify the device
name may make the unit difficult to recognize in
situations where more than one unit is being dealt
with at the same time (for example, when using
utilities such as the FMQuadro network map).
NOTE
If the Disabled option is chosen, you can still
reboot or do a hard reset of the unit using the
Configurator GUI. See
factory defaults" (page 139)
information.
set to its factory default configuration (enabled).
"Resetting the unit to
for more
Page 123 of 177