Cisco FLUIDMESH FM3200 Endo Installation And Configuration Manual page 130

Backhaul FM3200 Endo Cisco Ultra-Reliable Wireless
3. Download the firmware image (*.BIN) file to your computer.
The following procedure describes how to overwrite the existing firmware
on a Fluidmesh device. This procedure assumes that the wireless network
is currently active.
To overwrite the existing firmware on the Fluidmesh device, do the
following steps:
1. Power OFF all Fluidmesh devices connected to the wireless
network.
2. Disconnect all Ethernet cables from the Fluidmesh device.
3. With the Fluidmesh device disconnected from the wireless
network, power ON the device.
4. Connect the computer containing the firmware image file directly
to the Fluidmesh unit, using an Ethernet cable. For detailed
information on direct connection, refer to
FM3200 Endo for device configuration" (page
5. As a precaution, save the unit's existing device configuration file
to the computer. For detailed information on how to save the
existing configuration file, refer to
settings" (page
6. Click the -firmware upgrade link under MANAGEMENT
SETTINGS in the left-hand settings menu.
• The FIRMWARE UPGRADE dialog will be shown
© 2020 Cisco and/or its affiliates. All rights reserved.
CAUTION
Make sure that you download the specific *.BIN file
for your device type. Uploading incorrect firmware for
the device type will cause the firmware overwrite to
fail, and may damage the unit.
CAUTION
Do not restart or power OFF the device while
firmware overwriting is in progress.
Restarting or powering OFF the unit before
overwriting is complete will permanently damage the
unit.
137).
(Figure 55 (page 131)).
"Accessing the Cisco
47).
"Saving and restoring the unit
Page 130 of 177