Cisco FLUIDMESH FM3200 Endo Installation And Configuration Manual page 98

Backhaul FM3200 Endo Cisco Ultra-Reliable Wireless
However, depending on network configuration, it may be convenient to
forward multicast traffic from one Mesh Point unit to another Mesh Point
unit, to allow such tasks as remote recording of the video data flow.
By default, units operating in Mesh End mode do not forward multicast
traffic to a wireless network. The only exceptions to this rule are universal
plug and play (UPnP) and Internet Group Management Protocol (IGMP)
traffic.
To redirect traffic flow to a Mesh Point unit, all multicast flow redirection
information must be specified using the Multicast settings on a Mesh End
unit.
To set multicast rules on a Mesh End unit, do the following steps:
1. Find the Mesh End unit in the wireless network that is most
suitable for forwarding multicast traffic.
2. Connect to the Mesh End unit as shown in
FM3200 Endo for device configuration" (page
3. Click the -multicast link under ADVANCED SETTINGS in the
left-hand settings menu.
• The MULTICAST dialog will be shown
© 2020 Cisco and/or its affiliates. All rights reserved.
NOTE
To change the unit's Multicast settings, make sure that the unit
is in Mesh End mode as shown in
mode" (page 57). Multicast controls are not available if the unit
is set to Mesh Point mode.
NOTE
Multicast flow redirection information can only be
specified from a Mesh End unit. The Mesh End unit
will distribute the multicast data to all other Fluidmesh
devices in the wireless network.
99)).
"Changing the operational
"Accessing the Cisco
47).
(Figure 38 (page
Page 98 of 177