Miscellaneous Settings - Cisco FLUIDMESH FM3200 Endo Installation And Configuration Manual

Backhaul FM3200 Endo Cisco Ultra-Reliable Wireless

7.6.14. Miscellaneous settings

The MISC SETTINGS window contains controls to change the following
settings:
• The device name, as used to identify the Cisco FM3200 Endo
within the FMQuadro network map and to other Fluidmesh utilities.
• The operation of the physical Reset button on the unit.
• Device firmware upgrades by trivial file transfer protocol (TFTP).
• The unit's federal information processing standards (FIPS) 140-2
compliance settings (if applicable).
• The unit's controller area network (CANBUS) support settings (if
applicable).
• The unit's process field net (PROFINET) support settings (if
applicable).
• The unit's Neutrino Qnet (QNET) support settings (if applicable).
To change any of the miscellaneous settings, do the following steps:
1. Click the -misc settings link under ADVANCED SETTINGS in
the left-hand settings menu.
• The MISC SETTINGS dialog will be shown
© 2020 Cisco and/or its affiliates. All rights reserved.
IMPORTANT
Support for FIPS, CANBUS, PROFINET and QNET are only
available if the corresponding plug-ins are installed. If the
corresponding plug-in is not installed, the check-box for the
relevant option will not be available.
The following plug-ins are needed to activate these features:
• FIPS: FM-FIPS
• CANBUS: FM-CANBUS
• PROFINET: FM-PROFINET
• QNET: FM-QNET
Note that FIPS support is not available for the FM1000
Gateway and FM10000 Gateway.
Contact your Fluidmesh Networks representative for details.
(page 123)).
(Figure 49
Page 122 of 177