Heat Radiation Data - Cisco FLUIDMESH FM3200 Endo Installation And Configuration Manual

Backhaul FM3200 Endo Cisco Ultra-Reliable Wireless

11. HEAT RADIATION DATA

When in use, all Fluidmesh gateway units and radio transceivers generate
heat as a by-product of electrical activity.
Heat radiated by a Fluidmesh device may be of concern in confined
locations such as server rooms (where the cumulative heat generated by
a collection of electrical and electronic devices may cause damage to
sensitive electronic components) and outdoor equipment enclosures (in
which electronic components may overheat if the enclosure is not properly
ventilated).
WARNING
The outer surfaces of some Fluidmesh units may become hot
during normal operation. Such units have a 'Hot Surfaces'
warning triangle on their outer enclosures.
During normal operation, do not touch or handle such unit
enclosures without personal protective equipment.
The following table shows nominal heat-radiation figures for all Fluidmesh
devices under idle conditions, and under full-load conditions.
All heat-radiation figures are given in British Thermal Units (BTU) per
hour.
Device
FM1000
Gateway
gateway
FM10000
Gateway
gateway (first
and second
generations)
FM Ponte kit
FM1200 Volo
All Cisco 3200-
series
transceivers
Cisco FM3500
Endo
FM4200 Mobi
FM4200 Fiber
FM4500 Mobi
© 2020 Cisco and/or its affiliates. All rights reserved.
Fiber- Idle @
optic 115 Vac / 230 Vac /
module 60 Hz
installed
25.590 33.780
271.595 267.159
6.479 6.138
6.479 6.138
10.230 10.230
9.889 9.889
10.230 10.230
No 12.617 12.617
Yes 15.004 15.004
9.889 9.889
Idle @ Full load Full load
@ 115 @ 230
60 Hz Vac / 60 Vac / 60
Hz
25.250 33.100
436.395 437.078
19.778 19.437
19.778 19.437
24.552 24.552
26.939 26.939
24.552 24.552
26.939 26.939
29.326 28.985
26.939 26.939
Page 163 of 177
Hz