Management Settings; View Mode Settings - Cisco FLUIDMESH FM3200 Endo Installation And Configuration Manual

Backhaul FM3200 Endo Cisco Ultra-Reliable Wireless
4. To enforce FIPS 140-2 compliance for data transmitted by the
unit, make sure the FM-FIPS plug-in is installed, then check the
Enable FIPS: check-box.
5. To enable CANBUS support for the unit, make sure the FM-
CANBUS plug-in is installed, then check the Enable CANBUS:
check-box.
6. To enable PROFINET support for the unit, make sure the FM-
PROFINET plug-in is installed, then check the Enable
PROFINET: check-box.
7. To enable QNET support for the unit, make sure the FM-QNET
plug-in is installed, then check the Enable QNET: check-box.
8. To enable automatic device firmware updates using TFTP, do the
steps that follow:
a.
b.
c.
d.
9. Save the miscellaneous settings by clicking the Save button.
Alternatively, clear the settings by clicking the Reset button.

7.7. Management settings

7.7.1. View Mode settings

The View Mode window allows the system administrator to grant and
prohibit access to device configuration settings by category.
© 2020 Cisco and/or its affiliates. All rights reserved.
Check the Enable Automatic Upgrade check-box.
Enter the IP address of the authorized TFTP server
containing the firmware-update source files in the TFTP
Server field.
Enter the periodic interval at which the device checks for
a newer firmware upgrade package in the Check Period
(hours) field.
To do an immediate check for a newer firmware upgrade
package, click the Check Now button.
• If a newer firmware package than the existing
package is found, the newer package will be
installed immediately.
Page 124 of 177