Using Snmp V3 - Cisco FLUIDMESH FM3200 Endo Installation And Configuration Manual

Backhaul FM3200 Endo Cisco Ultra-Reliable Wireless
3. SNMP traps can be enabled for significant system-related events.
If needed, enable SNMP event traps by checking the Enable
SNMP event trap: check-box, and enter the name of the network
management station (NMS) host in the NMS hostname: field.
4. You can also configure the unit to send SNMP traps at defined
periodic intervals. If needed, enable periodic SNMP traps by
checking the Enable SNMP periodic trap: check-box, and enter
the name of the network management station (NMS) host in the
NMS hostname: field.
5. Save the SNMP settings by clicking the Save button.
Alternatively, clear the settings by clicking the Reset button.

Using SNMP v3

To change the unit's SNMP mode to v3 and configure the unit accordingly,
do the following steps:
1. Click the SNMP mode drop-down, and click the v3 option.
• The SNMP v3 settings dialog will be shown
© 2020 Cisco and/or its affiliates. All rights reserved.
IMPORTANT
The NMS host to which traps are sent must have an
SNMP agent that is configured to collect SNMP v2c
traps.
(page 104)).
(Figure 43
Page 103 of 177