Danfoss 176F1784 Instructions

INSTALLATION OF USB EXTENSION CABLE INTO F-FRAME VLT
This instruction sheet is for the field installation of the USB extension cable into the door
of F-Frame VLT frequency converters. Note: This kit is applicable to drives built dur-
ing or after Week 40 of 2008. Frequency converters built prior to Week 40, 2008 do not
have the provisions for this kit.
Kit Part Number
176F1784
The frequency converter contains dangerous voltage. Disconnect power and follow lock-
out/tag-out procedures before working on this equipment.
The door on the rectifier section of
F-Frame VLTs are fitted with a
feed-through hole to accommodate
a USB extension cord so that the
controls can be accessed from a
laptop computer without requiring
access to the inside of the VLT.
With the rectifier door open, the
hole is located near the upper right
corner of the door. See Figures 1
and 2.
The feed-through hole is covered
by the decorative label on the out-
side and with a round sticker on the
outside.
Instruction No: 177R0091 V0 Jan 2009
INSTRUCTIONS
Kit Contents
•
USB extension cord
•
Tie wraps
•
Instruction Sheet 177R0091
WARNING
Figure 1. Location of USB feed-through hole.
®
Page 1 VLT is a registered trademark of Danfoss A/S
®
DRIVES