Display Settings; Mimic Function - Deif AGC 150 Operator's Manual

No. Name
13 Breaker symbols
14 Generator
15 Engine
16 Stop
17 Start
18 Load symbol
2.2

Display settings

To adjust for ambient lighting, configure the display settings.
Parameters > Basic settings > Controller settings > Display > Display control
Parameter Text
9151 Backlight dimmer
9152 Green LEDs dimmer
9153 Red LEDs dimmer
9154 Contrast level
9155 Sleep mode timer
9156 Enable (Sleep mode timer)
9157 Alarm Jump
9158 Engineering units
NOTE * Low numbers are minimum brightness and high numbers are maximum brightness.
2.3

Mimic function

With the mimic function you can select how the control buttons and LEDs are shown on the controller's display.
Parameters > Basic settings > Controller settings > Display > LED mimic
Parameter no.
6082
Operator's manual 4189341311B EN
Function
Green: Breaker is closed.
Red: Breaker failure.
Green: Generator voltage and frequency are OK. The controller can close the breaker.
Green flashing: The generator voltage and frequency are OK, but the V&Hz OK timer is still
running. The controller cannot close the breaker.
Red: The generator voltage is too low to measure.
Green: There is running feedback.
Green flashing: The engine is getting ready.
Red: The engine is not running, or there is no running feedback.
Stops the genset if SEMI-AUTO or Manual is selected.
Starts the genset if SEMI-AUTO or Manual is selected.
Green: The supply voltage and frequency are OK.
Red: Supply voltage/frequency failure.
Item
LED mimic
Range
0 to 15 *
1 to 15 *
1 to 15 *
-20 to +20
1 to 1800 s
OFF
ON
OFF
ON
Bar/Celsius
PSI/Fahrenheit
Default
12
15
15
0
60 s
ON
ON
Bar/Celsius
Range
Standard with genset
Standard
Guided with genset
Guided
Page 6 of 22