General Shortcuts - Deif AGC 150 Operator's Manual

2. Select Engine shortcuts.
3. Select ECU Diagnose.
The diagnostics timer is activated when you select ECU Diagnose, and the controller starts to read the ECU data when the
diagnostic timer expires. To configure this timer, go to Parameters in the utility software and select parameter 6701.
Force Regeneration
To inhibit or force regeneration:
1. Push the Shortcut
2. Select Engine shortcuts.
3. Select Force Regeneration.
4. Select Inhibit or Force.
3.8

General shortcuts

You can see your configured shortcuts in the General shortcuts menu. If you have not configured a shortcut, then the menu
is empty. Use the shortcuts when the controller is in SEMI-AUTO and manual mode.
More information
See General shortcuts in the AGC 150 Stand-alone Designer's handbook for how to configure the general
shortcuts.
On the controller
1. From the view menu, push the Shortcut
2. Use the Up and Down
3. Use the Up and Down
Operator's manual 4189341311B EN
button.
button to see the menu.
buttons to go to General shortcuts , and push the
buttons to go to select a shortcut.
button.
Page 17 of 22