About The Agc 150 Stand-Alone; Display, Buttons And Leds - Deif AGC 150 Operator's Manual

2. About the AGC 150 Stand-alone

2.1

Display, buttons and LEDs

No. Name
1 Power
2 Display screen
3 Navigation
4 OK
5 Back
6 AUTO mode
7 Silence horn
8 Shortcut menu
SEMI-AUTO
9
mode
10 Mains symbol
11 Close breaker
12 Open breaker
Operator's manual 4189341311B EN
Function
Green: The controller power is ON.
OFF: The controller power is OFF.
Resolution: 240 x 128 px.
Viewing area: 88.50 x 51.40 mm.
Six lines, each with 25 characters.
Move the selector up, down, left and right on the screen.
Go to the Menu system.
Confirm the selection on the screen.
Go to the previous page.
The controller automatically starts and stops (and connects and disconnects) the genset. No
operator actions are needed. The controller also automatically opens and closes the mains
breaker (open transitions, since there is no synchronisation).
Turns off an alarm horn (if configured) and enters the Alarm menu.
Access the Jump menu, Mode selection, Test, Lamp test
The controller cannot automatically start, stop, connect or disconnect the genset, or open and
close the mains breaker.
The operator or an external signal can start, stop, connect or disconnect the genset, or open or
close the mains breaker.
Green: Mains voltage and frequency are OK. The controller can close the breaker.
Red: Mains failure.
Push to close the breaker.
Push to open the breaker.
Page 5 of 22