Service View - Deif AGC 150 Operator's Manual

Status text
LOAD TAKE OVER MAN
LOAD TAKE OVER SEMI
LOAD TEST
LOAD TEST ###.#min
LTO ACTIVE
MAINS FAILURE
MAINS FAILURE IN ###s
MAINS f OK DEL ####s
MAINS U OK DEL ####s
MB TRIP EXTERNALLY
READY AMF AUTO
READY ISLAND AUTO
READY LTO AUTO
SELECT GENSET MODE
SHUTDOWN OVERRIDE
SIMPLE TEST
SIMPLE TEST ###.#min
START DG(s) IN ###s
START PREPARE
START RELAY OFF
START RELAY ON
STOP DG(s) IN ###s
3.5

Service view

You can use the service view to see the status of the controller. You can change the passwords in the service menu, but not
the other controller settings.
From the view menu, push the
parameters in the service view, and use the
Operator's manual 4189341311B EN
Condition
The controller is in manual mode and waiting for operator input.
The controller is in semi-automatic mode and waiting for operator input.
Test mode is activated.
Test mode is activated and test timer counting down.
The controller is in auto mode and taking over the load.
Mains failure and mains failure timer expired.
The frequency or voltage measurement is outside the limits. The timer shown is the mains
failure delay.
Mains frequency is OK after a mains failure. The timer shown is the mains OK delay.
The mains voltage is OK after a mains failure. The timer shown is the mains OK delay.
Some external equipment (not the controller) has tripped the breaker. An external trip is
logged in the event log.
The genset controller is in auto mode and the genset is stopped.
The genset controller is in auto mode and the genset is stopped.
The genset controller is in auto mode and the genset is stopped.
No genset mode has been selected.
The configurable input is active.
Test mode is activated.
Test mode is activated and test timer counting down.
The start genset set point has been exceeded. The genset will start when the timer expires.
The start prepare relay is activated.
The start relay is deactivated during the start sequence.
The start relay is activated.
The stop genset set point has been exceeded. The genset will stop when the timer expires.
button and select Service View . Use the
button to select the parameters.
and buttons to go through the
Page 14 of 22