Table of Contents
Advertisement
Installation Requirements
Figure 9. UPS Rackmount Installation
Screw back in the metal protection cover, connect the BMS connector together and install the screws for the
front panel, then clip the center cover.
The rails and necessary hardware are supplied by EATON.
3 3 . . 6 6
I I n n s s t t a a l l l l a a t t i i o o n n R R e e q q u u i i r r e e m m e e n n t t s s
Recommended protective devices and cable cross-sections.
1.
Recommended upstream protection
16
Eaton 9PX Lithium-Ion User Guide DPD-9PX2205—Rev 01
1
2
4
UPS Power Rating
6000VA
3
4
5
Upstream circuit breaker
D curve — 32A
Advertisement
Table of Contents
