Table of Contents
Advertisement
Figure 8. Removal of the Battery Pack
5
To remove the battery pack:
1.
Remove the center cover of the front panel.
2.
Remove the two screws to open the left side of the front panel.
3.
Disconnect the BMS battery connector.
A ribbon cable connects the LCD control panel to the UPS. Do not pull on the cable or disconnect it.
4.
Remove the two screws that hold the metal protection cover in place.
5.
Carefully guide the BMS cable through the hole in the metal protection cover and remove.
6.
Pull out the handle of the battery pack, and slide the pack out slowly on to a flat and stable surface. Use
two hands to support the battery pack.
I I n n s s t t a a l l l l i i n n g g t t h h e e U U P P S S o o n n t t h h e e R R a a i i l l s s
Follow steps 1 to 5 for module mounting on the rails.
1
2
Eaton 9PX Lithium-Ion User Guide DPD-9PX2205—Rev 01
Rack Installation
3
4
6
15
Advertisement
Table of Contents
