Configure Vehicle Detection - HIKVISION DS-96000NI-M8 Series User Manual

3. Select a camera to configure.
4. Check Enable Face Capture.
5. Optional: Check Save VCA Picture to save the captured pictures of face detection.
6. Set the detection sensitivity.
Note
Sensitivity range: [1-5]. The higher the value is, the easier faces will be detected.
7. Set the arming schedule. Refer to Configure Arming Schedule .
8. Set linkage actions. Refer to Configure Linkage Actions .
9. Click Apply.

6.2.3 Configure Vehicle Detection

Vehicle detection, available in the road traffic monitoring, is tend to detect the passed vehicle on
the road, and capture its license plate at the same time.
Steps
1. Go to Smart Analysis → Smart Event Settings → Vehicle Detection .
2. Select a camera.
3. Click Vehicle.
4. Check Enable Vehicle Detection.
5. Optional: Check Save VCA Picture to save the captured vehicle detection pictures.
6. Configure rules, including Area Settings, Picture, Overlay Content, and Blocklist and Allowlist.
Area Settings
Up to 4 lanes are selectable.
Network Video Recorder User Manual
Figure 6-5 Face Capture
55