Vehicle Detection; Configure Vehicle Detection - HIKVISION IDS-9664NXI-I8/X(STD)(C) User Manual

4. Optional: Check Save VCA Picture to save the captured intrusion detection pictures.
5. Optional: Check Enable NVR Smart Analysis. The device will analyze the video, cameras only
transmit video stream.
6. Set detection area.
1) Click Draw Area.
2) Adjust the red frame on the image to draw the detection area. It is full screen by default.
3) Click Stop Drawing.
7. Optional: Set Capture Quality. The captured picture will be stored to the device, high quality
brings higher resolution, but it takes larger storage space. Picture quality will not affect
detection accuracy.
8. Set the arming schedule. Refer to Configure Arming Schedule .
9. Set the linkage method. Refer to Configure Linkage Actions .
10. Click Apply.

6.7 Vehicle Detection

Vehicle detection is available for the road traffic monitoring. In vehicle detection, the passed
vehicle can be detected and the picture of its license plate can be captured. You can send alarm
signal to notify the surveillance center and upload the captured picture to FTP server.

6.7.1 Configure Vehicle Detection

Vehicle detection is available for road traffic monitoring. In Vehicle Detection, a passed vehicle can
be detected and the picture of its license plate can be captured. You can send an alarm signal to
notify the surveillance center and upload the captured picture to an FTP server.
Steps
1. Go to Smart Analysis → Smart Event Settings → Vehicle Detection .
2. Select a camera.
3. Click Vehicle.
Network Video Recorder User Manual
99