Table of Contents
Advertisement
Figure 35. Installing the heat sink onto the processor
Next steps
1.
Install the processor and heat sink module
2.
Install the airshroud
3. Follow the procedure listed in
Installing a processor and heat sink module
Prerequisites
CAUTION:
Never remove the heat sink from a processor unless you intend to replace the processor. The heat
sink is necessary to maintain proper thermal conditions.
WARNING:
The heat sink may be hot to touch for some time after the system has been powered down. Allow the
heat sink to cool before removing it.
Follow the safety guidelines listed in
Steps
1. Align the pin 1 indicator of the heat sink to the system board and then place the processor and heat sink module (PHM) on
the processor socket.
CAUTION:
To avoid damaging the fins on the heat sink, do not press down on the heat sink fins.
NOTE:
Ensure that the PHM is held parallel to the system board to prevent damaging the components.
2. Push the blue retention clips inward to allow the heat sink to drop into place.
After working inside your
Safety
instructions.
system.
Installing and removing system components
43
Advertisement
Table of Contents
