Optional Idsdm Module; Removing The Idsdm Module - Dell 7HT3R Installation And Service Manual

3. Using the Phillips #1 screwdriver, secure the M.2 SSD module on the M.2 BOSS card with the screw.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 106. Installing the M.2 SSD module
Next steps
1. If applicable, Install the M.2 BOSS card into the M.2 BOSS
2. If applicable, Install the M,2 BOSS
3. Follow the procedure listed in the

Optional IDSDM module

Removing the IDSDM module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the air shroud.
4. If you are replacing the IDSDM card, remove the MicroSD cards.
NOTE: Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into
the corresponding slots.
Steps
Holding the pull tab, lift the IDSDM card out of the system.
104 Installing and removing system components
riser.
After working inside your
Safety instructions.
Before working inside your
riser.
system.
system.