Table of Contents
Advertisement
8. Select the TPM Advanced Settings option.
9. From the TPM2 Algorithm Selection option, select SHA256, then go back to System Security Settings screen.
10. On the System Security Settings screen, from the Intel TXT option, select On.
11. Save the settings.
12. Restart your system.
rSPI card
NOTE:
The inlet temperature sensor is located on the rSPI card.
Removing the rSPI card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the system board
Steps
1. Using the Torx #8 screwdriver, remove the screw securing the rSPI card to the system board.
2. Holding the rSPI card by its edges, lift the card away from the system.
CAUTION:
To prevent damage to the rSPI card, you must not tilt the card while lifting it from the system
board.
Figure 57. Removing the rSPI card
Next steps
Install the rSPI
card.
66
Installing and removing system components
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
