Figure 42. Installing the PCIe mezzanine card
Next steps
Follow the procedure listed in
Storage controller card
Removing the storage controller card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the following:
a.
Drives
b.
Drive backplane
c.
Drive cage
Steps
1. Using the Phillips #2 screwdriver, loosen the retention screws on the drive cable connector and lift it away from the storage
controller card.
CAUTION:
To prevent damage to the storage controller card, you must hold the card only by its edges.
2. Lift the storage controller card away from the system.
50
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
system.
system.