After Finishing Work - Stihl RE 100.0 PLUS CONTROL Instruction Manual

11 After Finishing Work

► Select the distance between the nozzle and
the surface to be cleaned so that the sur‐
face to be cleaned is not damaged.
► Adjust the 3-in 1 nozzle so that the surface
to be cleaned is not damaged.
► Adjust the 3-in 1 nozzle only when the lever
of the spray gun is not pressed.
► Move the spraying equipment evenly along the
surface to be cleaned.
► Move forward slowly in a controlled manner.
10.6 Working with Detergent
Detergents can increase the cleaning effect of
the water.
STIHL recommends the use of genuine STIHL
detergents.
► Remove the detergent bottle (3).
► Unscrew cover (2).
► Dose and use detergent as described in the
instructions for use of the detergent.
► Screw the cover onto the detergent bottle (3)
and tighten it by hand.
► Insert the detergent bottle (3) into the holder
(1) on the pressure washer.
► Rotate 3-in-1 nozzle into position
the highest power level.
11 After Finishing Work
11.1 After Finishing Work
► If you used detergents: Rinse high-pressure
washer.
► Switch off the high-pressure washer and pull
the mains plug out of the socket.
0458-004-0121-B
1
2
3
and set
► If the high-pressure washer is connected to
the water supply: Turn off water supply.
► Press the spray gun trigger.
The water pressure is reduced.
► Lock the spray gun trigger.
► Disconnect the high-pressure washer from the
water source.
► Remove the water hose.
► Remove and clean the nozzle and spray
lance.
► Remove the spray gun and let the rest of the
water run out of the spray gun.
► Cleaning the high-pressure washer.
1
6
5
► Wind up the high-pressure hose (1) evenly
distributed over the reel.
► Coil the connecting cable (2) on the holder (3).
► Secure the connecting cable (2) using the clip
(4).
► Insert the detergent bottle (5).
► Insert nozzle (6).
7
7
7
► Store the spray attachment in the holders (7)
on the high-pressure washer.
11.2 Protecting the pressure washer
with antifreeze
If the pressure washer cannot be protected from
frost during transport or storage, the pressure
washer should be protected by a glycol-based
antifreeze. The antifreeze prevents water inside
the pressure washer from freezing and causing
damage to the pressure washer.
► Remove spray lance
► Connect the shortest possible water hose to
the pressure washer.
The shorter the water hose, the less antifreeze
is needed.
English
2
3
4
7
7
17