Beacon 360
Backside
Fig. 02
04) Powercon connector IN
05) Powercon connector OUT
06) 3-pin DMX signal connector IN
07) 3-pin DMX signal connector OUT
08) Ground/earth connection
09) Power switch ON/OFF
10) Fuse 3A/250V
Installation
Remove all packing materials from the Beacon 360. Check that all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Ordercode: 45051
8