Seagull Models Grumman F8F Bearcat Assembly Manual page 8

GRUMMAN F8F BEARCAT
Once adjusted, make sure all clevis re-
tainers are in position. Apply a drop of
threadlock near the clevis, then tighten
the nut against the clevis to keep the link-
age from changing length inside the wing.
10.
11.
Set the lap control at the transmitter to
the down lap position. Adjust the lap
travel at the transmitter until it matches
the control throws listed in this manual.
12.
8
Instruction Manual.
Trim the lap linkage cover using a hobby
knife and hobby scissors.
13.
14.
Fit the lap linkage cover into position.
Check the operation of the lap to make
sure the cover does not interfere with the
lap linkage.
15.
Use canopy glue to attach the cover to the
wing. Use low-tack tape to keep the cover
in position until the adhesive fully cures.