Maico ER 60 E Mounting And Operating Instructions page 25

12. Installation ‒ ER-UP/GH - single room
DANGER
Fire may spread if connection duct [19]
is incorrectly installed.
 Only use permitted cable sheathing
( chapter 11.1).
 Correctly attach connection duct to
exhaust socket.
6. Connect connection duct [19] to exhaust
socket [2] sealed for ventilation, e.g. with
cold-shrink tape.
7. Make the electrical connection  chap. 22.
8. Insert the plaster protective cover in the
housing.
9. Plaster in housing flush with front edge,
note tile thickness if necessary
 chapter 12.1.3.
12.1.5 ER-UP/GH ceiling installation,
single room
1. Take plaster protective cover [38] out of
ER-UP/GH housing.
NOTICE
The unit will be damaged and function
impaired if the fixing screws used are
incorrect / too long.
 Fixing screws may not penetrate into
ER-UP/GH housing. Use screws pro-
vided (mounting support UPM 60/100).
2. For suspended ceilings, cut mounting
support [37] to the required length, bend it
into shape and fix it to the ER-UP/GH
housing with the supplied fixing screws
( Fig. 7).
3. Mark fixing holes for mounting support
and/or ER-UP/GH housing on ceiling,
produce holes and insert dowels. Suitable
mounting material is to be supplied by the
customer.
20
DANGER
Risk of short-circuits and damage to
unit. If the cable grommet [39] is not
installed correctly, water may penetrate
the ER-UP/GH housing. Protection class
is not guaranteed.
 Drive through cable grommet so that it
can seal the cable sheathing all the way
round (circular, no slots).
4. Insert power cable [20] from rear of
housing through cable grommet [39] into
ER-UP/GH housing.
5. Move ER-UP/GH housing into desired
position and secure to ceiling with/without
mounting support.
DANGER
Fire may spread if connection duct [19]
is incorrectly installed.
 Only use permitted cable sheathing
( chapter 11.1).
 Correctly attach connection duct to
exhaust socket.
6. Secure connection duct [19] to exhaust
socket [2]. Then seal well for ventilation,
e.g. with cold-shrink tape.
7. Make the electrical connection
 chapter 22.
8. Insert plaster protective cover [38] in the
housing.
9. Plaster in housing flush with front edge.