Maico ER 60 E Mounting And Operating Instructions page 23

7
2 Exhaust socket with plastic shutter
18 Main duct, steel folded spiral-seams duct
19 Connection duct, flexible aluminium duct
AFR 80 Ø 75/ Ø 80
20 Power cable
37 Mounting support UPM 60/100 (2 items)
38 Plaster protective cover
39 Cable grommet
40 Expanded rubber ER-MO
12.1.4 ER-UP/GH wall installation,
single room
1. Take plaster protective cover [38] out of
ER-UP/GH housing.
NOTICE
The unit will be damaged and function
impaired if the fixing screws used are
incorrect / too long.
 Fixing screws may not penetrate into
ER-UP/GH housing. Use screws pro-
vided (mounting support UPM 60/100).
12. Installation ‒ ER-UP/GH - single room
2. Cut the mounting support [37] to the
required length, bend it into shape and
fix it to the ER-UP/GH housing with the
supplied fixing screws.
3. Mark fixing holes for mounting support on
rear shaft wall, produce holes and insert
dowels. Suitable mounting material is to
be supplied by the customer.
DANGER
Danger of short-circuits and damage to
the unit. If the cable grommet [39] is not
installed correctly, water may penetrate
the ER-UP/GH housing. The degree of
protection can no longer be guaranteed.
 Drive through cable grommet so that it
can seal the cable sheathing all the way
round (circular, no slots).
4. Insert power cable [20] from rear of
housing through cable grommet [39] into
ER-UP/GH housing.
5. Insert the ER-UP/GH housing with the
mounting support [37] into the shaft and
fix it to the rear wall of the shaft.
19