Introduction; Equipment - ESAB Aristo Mig WeldCloud U5000i Instruction Manual

2 INTRODUCTION

2 INTRODUCTION
The Mig U5000i WeldCloud™ is a GMAW/TIG welding power source, which can also be
used for SMAW (Shielded Metal Arc Welding).
The manual is valid for:
• Mig U5000i with WeldCloud™ unit
• Mig U5000iw with cooling unit and WeldCloud™ unit
NOTE!
These instructions describe a Mig U5000iw WeldCloud™ with a cooling unit.
The power source is intended for use with the Feed 3004 or Feed 4804 wire feed units.
All the settings are made from the wire feed unit or control box.
The Mig U5000i WeldCloud™ power source is combined with U8
box which enables wireless monitoring.
ESAB accessories for the product can be found in the "ACCESSORIES" chapter of
this manual.
For more information about feed units, refer to the Instruction manuals.
For more information about WeldCloud™, refer to the Quick start guide.
2.1

Equipment

The power source is supplied complete with terminating resistor and instruction manual.
0463 666 001 - 11 -
and provides a control
2
© ESAB AB 2020