Table of Contents
Advertisement
4 INSTALLATION
4
INSTALLATION
The installation must be carried out by a professional.
NOTE!
Mains supply requirements
This equipment complies with IEC 61000-3-12 provided that the short-circuit power is
greater than or equal to S
the public system. It is the responsibility of the installer or user of the equipment to
ensure, by consultation with the distribution network operator if necessary, that the
equipment is connected only to a supply with a short-circuit power greater than or
equal to S
scmin
4.1
Lifting instructions
Power source
4.2
Placing
Position the welding power source such that its cooling air inlets and outlets are not
obstructed.
4.3
Primary input
WARNING!
ELECTRIC SHOCK CAN KILL! PRECAUTIONARY MEASURES SHOULD BE TAKEN
TO PROVIDE MAXIMUM PROTECTION AGAINST ELECTRIC SHOCK. BE SURE
THAT ALL POWER IS OFF BY OPENING THE LINE (WALL) DISCONNECT
SWITCH WHEN PRIMARY ELECTRICAL CONNECTIONS ARE MADE TO THE
POWER SOURCE. BE SURE TO CHECK YOUR INPUT LEADS WITH A
VOLTMETER TO MAKE SURE ALL POWER IS OFF.
0463 666 001
at the interface point between the user's supply and
scmin
. Refer to the technical data in the TECHNICAL DATA chapter.
Trolley and power source
- 14 -
Trolley 2 and power source
© ESAB AB 2020
Advertisement
Table of Contents
