Disassembling Rear Shock Absorber - Benelli TNT125 Maintenance Manual

●In order to adjust the spring pre-tightening force, rotate the
adjusting nut [A] to the suitable position and tighten the lock
nut [B] with a hook wrench (the rear shock absorber is fixed
on the frame).
Special Tool—Hook Wrench
★If you feel that the spring is too soft or hard, please adjust
it!
Adjusting Spring
Spring Dampin Settin
length g force g
Weak Soft
141mm
↑ ↑
↑
↓
↓ ↓
80.8m
Strong Hard
m

Disassembling Rear Shock Absorber

●Disassemble:
Right Guard (see "Frame"—"Disassembling Right
Guard"),
Rear lower fender
Arm"—"Disassembling Rear Lower Fender")
●Lift the rear wheel above the ground with a jack.
Special Tool—Jack:
Jack Accessories:
●Remove the rear shock absorber clamp bolt [A] at the
upper side
Load Road Spee
conditio d
n
Light Good Low
↑ ↑ ↑
↓ ↓ ↓
Heav Bad High
y
(see "Rear Swing
- 352 -