Installing Rear Brake Pad; Checking The Wear Of Brake Pad; Master Cylinder; Disassembling Front Master Cylinder - Benelli TNT125 Maintenance Manual

●Disassemble:
Brake pad [A]

Installing Rear Brake Pad

●Push the calipers inward as far as possible.
●Install:
The operations should be conducted in reverse order of
disassembly.
●Install calipers (see "Installing Calipers")
●Check: brake fluid level [A], if it is lower than the
minimum score, add
recommended until it reaches the correct level.
●Check: brake handle operation, if the brake handle
feels loose and soft, or light and soft, empty the air
from the brake circuit.
Warning
Grasp the brake lever, until brake pad is against
the brake disc, so that the brake lever can
function as normal. Do not ride the motorcycle
before you complete the above steps! Because if
you do not complete the above operation, brake
may not work normally when being used for the
first time and thus danger is caused.

Checking the Wear of Brake Pad

●See "Regular Maintenance"—"Checking the Wear of Brake pad".

Master Cylinder

Disassembling Front Master Cylinder

●Disassemble the mounting bolt of front master
cylinder [A].
●Disconnect the connector of front brake lamp switch.
Note
If brake fluid spills out, please rinse immediately!
sufficient brake fluid
- 329 -