Leveling The Library - Quantum PX720 Unpacking And Installation Instructions

Quantum PX720 Unpacking and Installation Instructions
Document 6444602-04 A01
March 2005
Figure 23 Panel Shipping
Restraints Storage
Locations
Storing the Shipping
0
Materials
0

Leveling the Library

22
Panel restraint
storage locations
Left storage position shown
To store the shipping and packaging materials for future use:
1 Detach the ramp and place on top of the pallet.
2 Fold the shipping bag.
3 Place the shipping bag, foam cap, screws, internal library frame restraint,
and other packaging materials on the pallet.
4 Collapse the cardboard box.
5 Place the cardboard box on top of the packaging materials on the pallet.
6 Secure the pallet, packaging materials, and cardboard box for future use.
To level the library:
1 Rotate each foot of the library until it makes contact with the floor.
2 Rotate each foot an additional 1/4 turn with the open-end wrench to
begin raising the library.
3 Center a carpenter's level on the top front edge of the library.
4 Check the gauge on the level. If the front of the library is level, proceed to
step 6. If it is not level:
Determine which side of the library is low.
a
Adjust the leveling foot on the low side of the library by rotating the
b
leveling foot with the open-end wrench.
Unpacking the Library