Quantum PX720 Unpacking And Installation Instructions page 36

Quantum PX720 Unpacking and Installation Instructions
Document 6444602-04 A01
March 2005
Figure 34 Setup Screen
36
Back
The screen displays the following information:
Setup
• IP Address (requires cabinet reboot)
• IP Subnet Mask
• IP Gateway
• DHCP (default enabled)
• Change Password
• Restore Factory Settings
• Drive Autoclean
• Configured Drives
• Configured Slots
• Left Load Port (16)
• Right Load Port (32)
• Service Mode
6 To edit the setup information, use the up and down arrows to highlight
the section and press
• To set the IP address, subnet mask, and gateway, use the up and
down arrows to select the appropriate number and press
accept.
• To enable/disable DHCP, use the up and down arrows to toggle
between enable/disable. Press
library is not connected to a network which uses a DHCP server to
assign IP addresses, disable this function.
Installing the Quantum PX720 Library
Select
.
Select
to accept the setting. If your
Select
to
Select