Quantum PX720 Unpacking And Installation Instructions page 27

Figure 26 Connecting the
Tape Drives
3 Connect the host computers to the tape drives by routing SCSI cables up
through the base of the library and along the right-hand side of the
cabinet (see figure 26).
Start cabling with drive cluster 0 at the top of the library
Tech Tip:
and work down.
Terminators
SCSI cables
Make sure that all SCSI cables droop down slightly to ensure
Note:
that the back door closes.
4 Route an Ethernet cable up through the base of the library and connect
the front Ethernet port located on the right side of the cabinet controller to
the local network (see
Installing the Quantum PX720 Library
Quantum PX720 Unpacking and Installation Instructions
Host computers
Terminators
Terminators
Host computers
figure 27).
Document 6444602-04 A01
March 2005
Cluster with 2 tape drives
per bus
Host computers
Cluster with 1 tape drives
per bus
Host computers
27