ST STM32F74 Series Getting Started page 33

AN4661
1. PC13, PC14, PC15 and PI8 are supplied through the power switch. Since the switch only sinks a limited
amount of current (3 mA), the use of GPIOs PC13 to PC15 and PI8 in output mode is limited:
- The speed should not exceed 2 MHz with a maximum load of 30 pF.
- These I/Os must not be used as a current source (e.g. to drive an LED).
2. 5 V tolerant except when in analog mode or oscillator mode for PC14, PC15, PH0 and PH1.
3. If the device is delivered in an WLCSP143, UFBGA176, LQFP176 or TFBGA216 package, and the
BYPASS_REG pin is set to VDD (Regulator OFF/internal reset ON mode), then PA0-WKUP is used as an
internal reset (active low).
DocID027559 Rev 2
Reference design
33/45
44