Table of Contents
Advertisement
Chapter 2 Preparations
3.
Hold the tray firmly and pull it toward the front.
1.12.6
Removing the 3.5-inch HDD cage
Remove the 3.5-inch HDD cage from the server by using the following procedure.
1.
See steps 1 to 3 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
To remove the side cover and front bezel, see Chapter 2 (1.4 Removing the Side Cover and 1.5
Removing the Front Bezel).
3.
To remove the hard disk drives installed in the HDD cage, see Chapter 2 (1.12.5 Removing the
3.5-inch hard disk drives).
4.
Disconnect the interface cable and power cable from the backplane installed in the HDD cage.
5.
Disconnect the interface cable from the motherboard or RAID controller.
6.
Remove four screws that attach the HDD cage.
7.
Remove the HDD cage from the server.
Note
Do not pull the handle to remove the hard disk drive.
Doing so may damage the handle.
Important
Do not use this server while removing the hard disk drive.
Express5800/T110g-E User's Guide
1. Installing Internal Optional Devices
85
Advertisement
Table of Contents
