Table of Contents
Advertisement
Chapter 2 Preparations
Install a 2.5-inch HDD cage and hard disk drives in the server by using the following procedure.
1.
See steps 1 to 3 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
To remove the side cover and front bezel, see Chapter 2 (1.4 Removing the Side Cover and 1.5
Removing the Front Bezel).
3.
Set the jumper for the backplane installed in the HDD
cage. The jumper setting when the onboard SATA
controller (LSI Embedded MegaRAID) is used differs
from that when the optional RAID controller is used.
For details, see 1.9 Use of Internal Hard Disk Drives
in the RAID System.
4.
Insert the HDD cage into the HDD bay. The "TOP"
must face rightward.
5.
Attach the HDD cage by using the four screws.
6.
Connect the interface cables and power cable to the backplane board installed in the HDD cage.
Use the interface cables that come with the HDD cage. For details about cable connection, see
1.16 Connecting Cables.
7.
Reassemble the server.
Express5800/T110g-E User's Guide
1. Installing Internal Optional Devices
The "TOP"
must face
rightward.
87
Advertisement
Table of Contents
