Table of Contents
Advertisement
Chapter 2 Preparations
Connecting the flash backup unit control cable
To connect the flash backup unit control cable into the battery pack, see the following figure. Check the
form of the connector and connect the cable straight into the connector.
Getting ready to install the battery
1.
See Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
To remove the side cover and the front bezel, see Chapter 2 (1.4 Removing the Side Cover and
1.5 Removing the Front Bezel).
Installing the flash backup unit
1.
Slide out and remove the battery bracket, holding onto the tabs.
Express5800/T110g-E User's Guide
1. Installing Internal Optional Devices
65
Advertisement
Table of Contents
