Figure 94. Installing the BOSS-N1 card carrier
Next steps
1. Follow the procedure listed in
After working inside your
system.
Removing the BOSS-N1 cage
Prerequisites
1. Follow the safety guidelines listed in the
Safety
instructions.
2. Follow the procedure listed in the
Before working inside your
system.
3. Remove the expansion card riser 4A.
Steps
1. Using a Phillips 2 screwdriver, loosen the two blue thumb screws that secures the BOSS-N1 cage to the system.
2. Lift the BOSS-N1 cage away from the system.
Installing and removing system components
119