Removing Expansion Card From The Expansion Card Riser - Dell PowerEdge XE8640 Installation And Service Manual

Removing expansion card from the expansion card riser

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If applicable, disconnect the cables from the expansion card.
4. Remove the expansion card
Steps
1. For Riser 1A, first pull the black card holder before removing the card from the Riser 1A. Pull and lift the expansion card
retention latch lock to open. Hold the expansion card by the edges, and pull the card until the card edge connector
disengages from the expansion card connector on the Riser 1A.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 63. Removing expansion card from Riser 1A
2. For Riser 4A, first pull and lift the expansion card retention latch lock to open. Pull the black card holder before removing the
card from the Riser 4A. Hold the expansion card by the edges, and pull the card until the card edge connector disengages
from the expansion card connector on the Riser 1A.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Safety instructions.
Before working inside your
riser.
system.
Installing and removing system components 99