Table of Contents
Advertisement
CAUTION:
Take care not to damage the system identification button while placing the system board into the
chassis.
2. Hold the blue plastic handle and sheet metal handle on the system board and place it onto the chassis.
3. Align the guiding features with their corresponding marks on the chassis.
4. Hold onto the blue plastic handle with one hand and use the other hand to push the plunger, sliding the system board
towards the rear of the chassis until it clicks and locks plunger.
NOTE:
Ensure the plunger is locked.
Figure 110. Installing the system board
Next steps
1. Replace the following components:
a.
Trusted Platform Module (TPM)
NOTE:
The TPM Module must be replaced only while installing new system board.
b.
OCP card (if install)
c.
OCP shroud (if install)
d.
Intrusion switch
e.
Processor
f.
Heat sink module
g.
Memory modules
h.
Expansion card risers 1 and 4
i.
BOSS-N1 cage
j.
BOSS-N1 card, M.2 SSD module, BOSS-N1 card carrier
k.
BOSS-N1 shroud
l.
Cooling fan cage
m.
Cooling fan
n.
Front top cover
o.
Air shroud
p. Observe and connect the cables to the connectors on the power distribution board.
q. Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable
securing bracket.
r.
Power supply units (PSU)
Installing and removing system components
133
Advertisement
Table of Contents
